Sensormatic RHODUL-01 Especificaciones descargar pdf (Pagina 11)

RHODUL OUTDOOR HOUSING INSTALLATION AND SERVICE GUIDE (8000-2830-05, REV. A)

11 of 14

Picture Grainy or Discolored

Check the fans. If they are not turning, the camera

dome may be overheating. See “Dome Does Not

Respond to Commands” on page 10.

Poor or No Video

See “Dome Does Not Respond to Commands” on

page 9.

Ice Forms On Bubble

Follow steps until the problem is corrected. See

page 12 to order parts.

1. Verify that fans in housing are working.

If not, see “Fans Do Not Turn” on page 10.

2. Determine if housing and eyeball assembly

is receiving power.

Look for evidence such as a picture on the

video monitor or dome movement.

3. Remove housing and eyeball assembly to

access environmental PC board.

Note: Power to heater comes from housing and

eyeball assembly. Heater will not function with

this assembly removed.

CAUTION: Touch metal housing before

handling environmental board.

4. Verify power is reaching housing.

Press and hold switch SW2 and observe the

green (ac power) LED. Green LED should glow

steadily. If not, check power at J-box and ac

cable plugged into connector P7 on other side

of environmental PC board.

CAUTION: Connector screws on ac connector

are delicate. DO NOT over tighten them! Use a

2.5mm (0.1") slotted screwdriver. Wider blade

widths can damage connectors.

1 2 ... 6 7 8 9 10 11 12 13 14

Sin comentarios

Sensormatic RHODUL-01 Especificaciones Pagina 11