Sensormatic RHODUL-01 Especificaciones descargar pdf (Pagina 4)

RHODUL OUTDOOR HOUSING INSTALLATION AND SERVICE GUIDE (8000-2830-05, REV. A)

4 of 14

CAUTIONS

 You should have two boxes: one for the outdoor

housing, the other for the bubble assembly.

Protect the bubble assembly by leaving it in its

box until you are ready to install it.

 Do not run data and power cables adjacent to

or in the same conduit as line voltage mains

power.

 SensorNet 485 networks require 22 AWG

unshielded

cable. Do not exceed 32 devices

per cable run.

 RS422 networks require 22 AWG shielded

cable. Do not exceed 10 devices per cable run.

 Manchester networks require 18 AWG shielded

cable. Do not exceed 3 devices per cable run.

 Always terminate the camera dome connected

at the end of a cable run.

 The outdoor housing contains an environmental

PC board. Touch the metal housing to

discharge static electricity before

touching this

board. Also, use a jeweler’s 2.5mm (0.1")

slotted screwdriver to tighten PC board

connectors. Wider blade widths can damage

connectors. Do not over tighten connectors.

 When connecting the housing and eyeball

assembly to the outdoor housing:

- Remove both

slot covers to keep the

camera from overheating

- Keep cables entering the housing away from

the heater assembly

- Check heater fan operation. Both fans must

be on to prevent overheating.

1 2 3 4 5 6 7 8 9 ... 13 14

Sin comentarios

Sensormatic RHODUL-01 Especificaciones Pagina 4