Sensormatic Intellex Guía para resolver problemas Pagina 18

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 190
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 17
Quick Reference Guide and Troubleshooting Guide
16 Quick Reference Guide
Installation
Insert the USB cable of the port expander into one of the USB connectors in the rear of
the Intellex. It is not necessary to exit Intellex. The unit will recognize the new device
and a New Hardware Found message will appear briefly. The port expander is ready
to use.
After the Intellex RS-232 4-Port Expander has been installed, you may continue with
the setup of the text recording interface.
Serial Interfaces and Text Recording
Internal COM ports
Intellex units with version 2.1 hardware or later have only one external serial port. It
should be configured as COM 2 and is dedicated to the Touch Tracker interface. (The
motherboard BIOS parameters for COM 2 are I/O Address=2F8, Interrupt=IRQ3).
Any additional serial ports must be added by means of a USB serial port expander.
Premier model Intellex 3.0 includes a USB RS-232 adapter that provides a single serial
port connection
Port Expanders
The serial port expander supported by Intellex is the Edgeport/4 by Inside Out
Networks. The Sensormatic part number is RDVEXP01.
Port Assignments
The serial port assignment is made by the Edgeport driver. It assigns COM ports
based on the serial number of the port expander. This means that if you plug one port
expander in and it is assigned serial port numbers COM 3-6, and you remove it and
plug in another port expander, it will then be assigned serial port numbers COM 7-10.
Always keep the same port expander with the same Intellex. If you switch Edgeports,
you must then renumber the COM port setup in Intellex.
COM Port Assignments
These are the COM port assignments that are expected by Intellex.
COM 1 Not used (disabled in the BIOS)
COM 2 Touch Tracker interface for “MUX” control of
Intellex and dome control from Network Client. On
rear of Intellex unit.
Vista de pagina 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 189 190

Comentarios a estos manuales

Sin comentarios