Sensormatic Intellex Guía para resolver problemas descargar pdf (Pagina 21)

Intellex Digital Video Management System

Quick Reference Guide 19

INSTALLING THE ESM AND CONVERTING TO NTFS

1. Plug the ESM into an open FireWire port and turn on the power to the ESM.

2. On the Intellex unit you will see several windows appear, each representing a new

drive in the ESM. Close each of these windows.

3. Double-click on My Computer, the four new drives will appear, each labeled

“Local Disk” with the drive letter in parentheses.

4. For each new drive right-click on the icon for the drive and select Properties.

5. In the Label box for each drive, enter a new label to identify the drive, and click

OK (e.g., ESM1a, ESM1b, numbers to denote the ESM module and a letter to

denote each drive in the ESM). This helps to identify each drive’s physical location

when connecting multiple ESMs to an Intellex unit.

6. Close the My Computer window.

7. Click Start, select Run, and type “cmd” in the Open field and click OK.

8. At the C: prompt type the command “convert [Drive Letter]: /fs:ntfs”.

9. The system may prompt you for the volume label of the drive you are converting;

if so, type in the label that you assigned to the drive in step 5.

10. Information will display on the screen while the drive is being converted. This

process will take a few minutes (the larger the drives in the ESM, the more time the

conversion takes). When you see the message “Conversion Complete“, the process

is finished.

NOTE: This conversion task must be executed on every drive in the ESM.

NOTE: When you add a new storage volume (like an ESM) to the Intellex, this

additional recording capacity is placed at the beginning of the database. This

means that the extra storage capacity is not included until the database size is

recalculated. If you are in Linear recording mode, any added volume(s) will

not be used to record video until the database is full and you are prompted to

click the Begin Record button.

NOTE: To remove an ESM from your Intellex unit, first exit the Intellex application to

the Windows Desktop. Then click on the Remove/Eject icon on the Taskbar

to disconnect the 1394/FireWire device. Wait for the message that it is safe to

remove the device, then disconnect the 1394/FireWire cable from the Intellex

unit. When you restart Intellex, you will be warned that the storage volumes

are missing. Now use the Storage Setup screen to remove the storage

volumes from the Intellex database.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 189 190

Sin comentarios

Sensormatic Intellex Guía para resolver problemas Pagina 21