Sensormatic VM96 INS Manual del operador descargar pdf (Pagina 47)

Using the TOUCH TRACKER 3-17

Note

Outputs within a Sequence will always change to their “closed” state when

the Sequence is initiated. For example, if the output is a light (and the

light’s closed state is “on”), then the light will turn on when the Sequence is

initiated. If the output is a door lock, (and the lock’s closed state is

“unlocked”), then the door will unlock when the Sequence is initiated. If,

when the Sequence is initiated, the output is already in its closed state, it will

remain in that state even after its dwell time is up.

Both types of sequences will run repeatedly until you select the monitor

where the Sequence is running and either:

· Press the

Seq button (which stops the Sequence permanently),

· Issue a camera command, i.e., pan, tilt, zoom, focus, iris (which also

stops the Sequence permanently), or

· Press the

Hold button (which stops the Sequence temporarily).

1 2 3 4 5 6 7 8 9 77 Lobby

12 Front Door

Seq. Name

12:21:31 P Mon May 17 1999

W1-M2A

Facility Name

Figure 3-10: Sequence information.

When you initiate a Sequence,

the Sequence Name is displayed

here.

As each action within the

Sequence is called up, its

corresponding name and

number are displayed here.

Notice that when the action

changes, so do the name and

number.

As each action within the

Sequence is called up, the

corresponding camera name

and number for which the action

was defined are displayed here.

Notice the name and number

change whenever the action

calls up a new camera.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 121 122

Sin comentarios

Sensormatic VM96 INS Manual del operador Pagina 47