Sensormatic VM96 INS Manual del operador descargar pdf (Pagina 53)

Using the TOUCH TRACKER 3-23

Clearing an Alarm

Detailed procedures on how to handle incoming alarms are provided in

Chapter 5, “Responding to System Alarms.” Briefly, when an alarm comes

into the system, it is displayed on the alarming monitors in whichever

Workstations that alarm was configured to be routed to. Alarms are

displayed on alarming monitors only. You will never see an alarm displayed

on a general monitor. Your System Administrator determined which

monitors are alarming and which are general; this is done on the Configure

Workstations form.

You can acknowledge and clear alarms via the T

OUCH TRACKER. To

acknowledge an alarm, select the monitor displaying the alarm, and then

press the

Ack button. When more than one alarm is active at one time, you

can acknowledge the alarm on whichever monitor your T

OUCH TRACKER is

currently connected to.

If there are more active alarms than there are alarming monitors in the

Workstation, the alarms will sequence on one of the monitors. When this

happens, you can select the monitor that is sequencing the alarms and press

the

Hold button; this puts the sequencing alarms on hold. Then press the

Prev and Next buttons to step through the active alarms. When the alarm

you want to acknowledge is displayed on the monitor you are connected to,

press the

Ack button.

If you acknowledge an alarm that was also routed to a Workstation other

than the one you are connected to, you will automatically clear the alarm

from that Workstation as well.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 121 122

Sin comentarios

Sensormatic VM96 INS Manual del operador Pagina 53