Sensormatic VM96 INS Manual del operador descargar pdf (Pagina 77)

Using the On-Screen User’s Menu 4-21

2. Select the Sequence you want to run—either by typing the Sequence

number and pressing

Seq, or by highlighting a Sequence from the

selection list and pressing the

Menu button.

The screen disappears and the selected Sequence begins running on the

monitor(s).

Both types of sequences will run repeatedly until you select the monitor

where the Sequence is running and press one of the following buttons:

Seq (to stop the Sequence permanently)

Hold (to stop the Sequence temporarily)

· pan, tilt, zoom, or focus button (to stop the Sequence permanently)

Remember, while a Sequence is running, you can pause it and step through

the individual actions in a Standard Sequence or through the individual

groups in a Salvo Sequence. This is described in Chapter 3, “Using the

OUCH TRACKER.”

Calling a Zone

A Zone is a group of pre-defined Quick Views, on separate cameras, that are

called up simultaneously. For example, there may be a Zone in a parking

garage that incorporates six cameras. Each camera calls up a Quick View of

a different entrance in the parking garage. When you initiate this Zone, all

six cameras will simultaneously pan and tilt to their assigned exits in the

parking garage, and then zoom and focus automatically.

Remember, you can call a Zone directly from the T

OUCH TRACKER keypad

by pressing the Zone number and then pressing

Zone. If you cannot recall

the Zone number, follow this procedure to call the Zone.

1. Press

Zone on the keypad to display the list of available Zones.

A list of available Zones and their associated numbers is displayed on

the monitor. Figure 4-10 illustrates a sample Zones screen.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 121 122

Sin comentarios

Sensormatic VM96 INS Manual del operador Pagina 77