Sensormatic SpeedDome Ultra IV Manual del operador descargar pdf (Pagina 13)

Getting Started 1-5

• Press Zoom In to move the cursor in the Password field to the right;

press Zoom Out to move the cursor in the Password field to the left.

As each character in the password is selected, asterisks (*) appear in the Password field.

When you have finished entering the password, use the Tilt control to move the highlight bar

to Continue, then press Focus Far. If the password has been correctly entered, the Dome

Configuration Menu appears. If the password was not entered correctly, the Enter

Password screen remains on the monitor.

If you do not want to start the configuration utility, use the Tilt control to move the highlight

bar to Cancel, then press Focus Far.

IMPORTANT

If you forget the password, contact technical support for instructions about

overriding the existing password.

Restoring Factory Settings

Note

Selecting Reset to Factory Settings from the Dome Configuration

Menu does not change the following settings: Camera Name, Alarm Names,

Area Names, Preset Names, Pattern Names, Area Boundaries, and Presets.

To reset names to the default settings, refer to Chapter 5, On-Screen Text

Display Settings.

Some screens provide a choice to Reset to Factory Settings. This choice applies only to

those settings currently displayed on the screen. To reset all configuration settings, choose

Reset to Factory Settings from the Dome Configuration Menu. You will see the

following prompt:

Reset to Factory Settings

Press Zoom In or Zoom Out to toggle the setting. If you want to restore the factory settings,

select Yes, then press Focus Far. If you do not want to restore the factory settings, select No,

then press Focus Far.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 75 76

Sin comentarios

Sensormatic SpeedDome Ultra IV Manual del operador Pagina 13