Sensormatic SpeedDome Ultra IV Manual del operador descargar pdf (Pagina 30)

Alarms, Areas and Home Settings 4-3

SET ALARM ACTIONS

EXIT

INPUT NO.

ACTION

SEND INPUTS TO HOST?

YES

NO ACTION

PRESET 96

PATTERN 3

NO ACTION

INTERNAL ALARMS

Figure 4-2: Set Alarm Actions Screen

Alarms can be processed internally by the dome, externally by the controller, or both.

Internal alarms are configured by setting a preset or pattern.

A preset is a programmed video scene, based on a specific pan, tilt, zoom, and focus settings.

A pattern is a series of pan, tilt, zoom and focus movements from a single programmable

dome.

For each of the four alarm inputs, you can choose to display a preset or pattern whenever the

alarm's input state changes from normal to abnormal. Or you may choose to have no internal

alarm associated with the input. You may also choose to send changes in the input state to the

host controller. If the changes in input state are sent to the host, the host actions have higher

priority than the associated dome actions.

Note

An active internal alarm only resets when the input state changes to

“normal.” A manual reset is not available.

Assigning Alarm Actions

IMPORTANT

Certain controllers allow the alarm actions for domes to be specified at the

controller. These controllers include VM16 Plus, VM32, VM96, ADTT16,

AD32, AD matrices with AD2083-02A code units, or AD168 with CCM or

AD2083-02A. Do not use both the dome configuration utility and the

controller to assign the alarm actions for the same input. Use only the

dome configuration utility or the controller to the assign the alarm actions.

To configure alarm actions, do the following:

1. Select Alarms/Areas/Home from the Dome Configuration Menu.

Highlight Bar:

Move up / down

with Tilt control.

Move right / left

with Pan control.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 75 76

Sin comentarios

Sensormatic SpeedDome Ultra IV Manual del operador Pagina 30