Sensormatic SpeedDome Ultra IV Manual del operador descargar pdf (Pagina 16)

2-2 Operator’s Manual

Overview of Pan, Tilt, and Zoom Settings

When Pan/Tilt/Zoom Options is selected from the Dome Configuration Menu, the

following screen appears:

PAN / TILT / ZOOM OPTIONS

PROPORTIONAL FLIP OFF

1ST ZOOM STOP X 24

MAX TOTAL ZOOM X 128

EXIT

RESET TO FACTORY SETTINGS

Figure 2-1: Pan / Tilt / Zoom Screen

From this screen you can, enable or disable the flip feature and set the first zoom stop and

maximum zoom settings.

• To move the highlight bar, use the Tilt control.

• Pressing Zoom Out or Zoom In changes value of the selected setting.

• If you want to save your changes, move the highlight bar to Exit, then press Focus Far

to return to the Dome Configuration Menu.

• If you want to change the settings for this screen to the factory defaults, move the

highlight bar to Reset to Factory Settings, then press Focus Far.

Setting the Automatic “Flip” Feature

The automatic (or proportional) “flip” feature allows the dome to automatically turn 180-

degrees when the camera tilts to its lower limit and stays in that position for a brief delay.

The duration of the delay is inversely proportional to the tilt speed.

When the dome flips (rotates), the camera starts moving upward as long as the tilt control is

kept in the down position. Once the tilt control is released, the control returns to its normal

operational mode. The flip feature is useful when you need to track someone who walks

directly beneath the dome and continues on the other side.

When the flip feature is disabled, the dome stops when the tilt down stop is reached.

To change the flip setting:

1. Select Pan/Tilt/Zoom Options from the Dome Configuration Menu.

The highlight bar appears on the Proportional Flip setting.

Highlight Bar:

Move with Tilt

control

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 75 76

Sin comentarios

Sensormatic SpeedDome Ultra IV Manual del operador Pagina 16