Sensormatic SpeedDome Ultra IV Manual del operador descargar pdf (Pagina 34)

Alarms, Areas and Home Settings 4-7

• If you want to define areas, continue with Programming Area Boundaries on

page 4-9.

• If you want to define presets, continue with Programming Presets on page 4-11.

• If you are finished making changes, press and hold Iris Close, then press Focus

Near or Focus Far to save your changes and exit the utility.

• If you want to make changes to other settings, use the Tilt control to move the

highlight bar to Exit, then press Focus Far. The Dome Configuration Menu

appears. Continue with What To Do Next on page 4-13.

Assigning the Dome’s Home Position

When Configure Home Position is selected from the Alarms/Areas/Home screen, the

following is displayed:

CONFIGURE HOME POSITION

EXIT

HOME POSITION PRESET 96

RETURN TIME MINS

Figure 4-4: Configure Home Position Screen

Use this screen if you want the dome return to a preset or run a pattern after a specified

period of inactivity.

Note

When a pattern is selected as the home position, the pattern runs until it

stopped manually by issuing a camera command such as tilt or focus.

Setting the Home Position

1. Select Alarms/Areas/Home from the Dome Configuration Menu.

2. Use the Tilt control to move the highlight bar to Configure Home Position, then press

Focus Far.

The highlight bar appears on the Home Position setting.

3. Press Zoom In or Zoom Out to change the setting.

This command is not supported with Manchester.

Highlight Bar:

Move with Pan/

Tilt control.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 75 76

Sin comentarios

Sensormatic SpeedDome Ultra IV Manual del operador Pagina 34